PROtect Optimist Kit

Optimist Kit is the complete kit designed by Ferndando Alegre to reduce the wear and tear, friction and possible failure.

Specifications and applications
Stripes of UHMWPE with with acrylic adhesive on liner:
-2 stripes 500 micron (20mil) translucent, 25mm (1") wide, 380mm (15") long for the bottom daggerboard case
-2 stripes 250 micron (10mil) translucent, 25mm (1") wide, 380mm (15") long for the bottom daggerboard case
-2 stripes 250 micron (10mil) black, 20mm (4/5") wide, 270mm (12") long for the top daggerboard case
-1 stripe 125 micron (5mil) translucent, 40mm (8/5") wide, 740mm (27.5") for the boat corners/rudder

Stripes of PTFE with with silicon adhesive on liner:
-2 stripes 50 micron (2mil) grey,  50mm (2") wide, 150mm (6") long for the mast step
-2 stripes 250 micron (10mil) light grey,  60mm (2.36") wide, 150mm (6") long for the sprit
-2 stripes 50 micron (2mil) light grey,  40mm (4/5") wide, 100mm (4") long for the friction between mast and sprit
-2 stripes 50 micron (2mil) light grey,  40mm (4/5") wide, 80mm (3 1/5") long for the friction between sprit block and the mast

PTFE tape with silicon adhesive linerless:
-1 roll 50 micron (2mil) light grey 50mm (2") wide, 10m (11yds) long for rigging

PTFE disk to adjust the mast step level from 1mm to 7.5mm
-2 disks of 1mm
-1 disk of 1.5mm
-2 disks of 2mm

Rubber black
-4 short pieces to block the centreboard
-2 short pieces to block the centreboard

Packaging
Crystal clear PET clamshell with eurohole and barcode